Tri-Pow’r

Detergent-Degreaser-Deodorizer

Ideal for microchannel

Suitable for any coil design

Rapid emulsification of grease and grime

Metal safe - can be used for evaporator no-rinse applications per instructions where ample condensate will self-rinse coil

NSF registered

This product must be used in accordance to the following directions by HVACR professionals only.

Goggles, gloves and other protective garments should be worn when using
this product. System must be shut off.

1. Apply using any of the Nu-Calgon sprayers or other durable, low
   pressure, plastic sprayer.
2. Prepare cleaning solution by mixing one part Tri-Pow’r HD with four
   parts water. Add the water to the sprayer first, then add Tri-Pow’r HD.
3. Spray Tri-Pow’r HD solution onto dirty surface and allow it to remain in
   contact for 5 minutes.
4. Rinse thoroughly with water.
5. Apply Cal-Shield® as a coil protectant and return system to service.
6. Rinse out sprayer, spraying wand and nozzle.
7. When the container is empty, rinse, replace cap and dispose of properly.

EVAPORATORS: Cleaning an evaporator coil in a “no-rinse” procedure can
be done by preparing a solution of 1 part Tri-Pow’r HD to 10 parts water and
applying with a sprayer. If this application is used, do so only where there is
sufficient humidity being condensed from the air to provide rinsing.

PERMANENT FILTERS: When cleaning greasy components
in a tub, add 1 ounce of Tri-Pow’r HD to each gallon of water. Allow
parts to soak for 15 minutes then rinse thoroughly with water.